The fully automatic vertical Lugs of plate layer is a component that connects the plate layers, providing limit points and suspension force for the pulling of the plate layers.
Lugs of plate layer uses stainless steel 304, 316 and other materials to connect the upper plate and the lower plate together, forming a stacked series structure from top to bottom.
When the hydraulic cylinder of the equipment drives the upper top plate to pull open or the lower bottom plate to fall, the pin moves with the plate layer from the upper hole of the Lugs of plate layer to the lower hole of the hanging ear pin, and begins to provide tension and maintain the spacing between the upper and lower plate layers.
- BLZG
- TPF
- HVPF
- LZB
- PF
- MQLY
- Larox
The plate layer should be checked for flatness on a daily basis.
Be careful not to perform cavity extrusion. The extrusion pressure of the vertical filter press is very high, which will cause the plate layer to deform.
If the plate layer has deformed, it is necessary to check whether it is caused by cavity extrusion in time and replace the relevant plate layer of the vertical filter press.
